|
|||||||
|
|
|
|||||
|
|
|||||||
Stock Assembly
Materials Needed:
1 - 3/4" X 6" X ?" Left over from trigger/receiver board
1" Thin walled pvc & 1" pvc connector
Drywall screws
Drill, Scroll or sabre saw, rotozip tool, Dremel tool
Printed Stock template : Stock (Right click & Save then print)
Instructions:
Print the template for the stock then trace it onto your board 2 times. After cutting out the pieces, use your wood glue and screws to attatch the 2 sides of the stock together, making sure they are square. The next step is to find a cutting bit that will be big enough to make the hole for your stock connector to fit into. I used 1" pvc with 1" connectors. To make the stock removeable you will need to make the hole in the front of the stock fit the 1" pvc. I used a 1" hole saw, but had to sand the hole to fit the pipe. See picture below for hole placement.
Once you have drilled the holes and test fitted all pipes and connectors for the receiver and the stock, they must be secured with glue and screws. Leave enough of the 1" pvc sticking out of the stock and receiver to trim back after putting the connector on. Don't trim too much or the pieces wont fit right. Just take a little off at a time to get the right fit to the connector. See the photo for details.
